Skip to content
ROCK your BABY

Getting started

Your first rocking session in five small steps.

[PHOTO: the device mounted on a cradle, buttons and lights visible]

1. Switch it on

Section titled “1. Switch it on”

2. Let it calibrate

Section titled “2. Let it calibrate”

Right after switching on, the device measures to find its balance point — the status lights pulse blue. This takes a few seconds.

  • Keep the device still while the lights pulse blue: don’t carry, rock or turn it.
  • When calibration is done, the status lights blink green about once per second. The device is now ready and waiting.

3. Give it a push

Section titled “3. Give it a push”

Gently rock the cradle by hand, the way you normally would.

  • While the device counts your swings, the green blinking gets faster.
  • After about five steady swings, the status lights turn solid green and the motor takes over — the rocking now continues on its own.

4. Adjust the strength

Section titled “4. Adjust the strength”

Press Plus or Minus to make the rocking stronger or gentler. There are five levels; the lights next to the buttons change color to show the level. Your choice is remembered for next time.

5. Stopping

Section titled “5. Stopping”

You don’t need to press anything to stop:

  • hold the cradle still for a moment, or
  • simply pick the device up.

The motor stops and the status lights go back to slow green blinking, waiting for the next push.

What’s next?

Section titled “What’s next?”

Manual version: v0.2.0